Off-form concrete, cement plastered wall, concrete surfaces, ceiling sheet and gypsum board.

1. First of all, get a sufficient amount of water into a bucket and then gradually add the SF - Super Coat while mixing.
2. Allow the mixture to stand for 5 minutes after the first round of mixing, and then begin a second round.
3. 3. To mix the SF - Super Coat, use a proper mixing instrument, otherwise you will not get a high-quality mixture.

• Apply evenly to substrate with a steel trowel or putty knife up to 1-2mm thick per coat.
• Recoat could be after first coat is fully dried or after 12 hrs (the trying time will depend on humidity)
• To get a smooth surface, use #320 or finer sandpaper.

Expertise for Application

We recommend that the product be applied by a person with the appropriate skills & experience. The acceptability of the surface is the responsibility of the applier.

Good preparation is essential. Surfaces must be firm, dry, clean and free from dust & loose, flaking, friable materials and substances that may diminish adhesion

Smooth surfaces should be roughened before applying SF - Super Coat.

Store in a dry place. Protect from moisture and bag damage. Available in 20 kg paper bags and 1 kg polythene packets.

On a smooth, cement plastered wall, the coverage is 1.5 - 2 m2/mm/kg. The coverage, however, depends on the type, condition, porosity, texture of the surface and application technique.

Though it contains only non-toxic materials, care should be taken to avoid dust inhalation while handling,mixing & sanding.
If it makes contact with your eyes, wash them using plenty of clean water.
The use of gloves, mask and goggles is recommended.

Do not apply in wet conditions or temperatures beyond the range of 5^oC and 45^oC.